Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a frame-relay interface which has this config:interface Serial0/1/0:0.500 point-to-point ip address 157.130.35.6 255.255.255.252 ip access-group 100 in frame-relay interface-dlci 500 crypto map CRX0do you know what command will give you ...
Hi,I have an IPSEC VPn to a site at another company. I would like to add a static rout in our VPn router, pointing to one of the subnets on the interior of our IPSEc peer's network. But, I'm not sure what the next hop should be for the static route...
Hi,I have a VPN up & running, which connects to another company. I would like to put in a static route in my router with a destination of one of the subnets on their network.What should I use as the next hop for the static route... their end of the ...
Hi, I have an access-list with the following line... permit ip host 65.119.114.3 62.140.152.0 0.0.0.31and its crypto ipsec sa shows up as this, with no packets encaps or decaps. protected vrf: local ident (addr/mask/prot/port): (65.119.114.3/...
Hi, I have an IPSEC tunnel which has one end at my company and the other end at another company, whose routers I don't control. I have an ipsec tunnel which appears to come up (isa sa is qm_idle but the ipsec sa shows no packets encrypted or decrypte...
Thanks I think I'm good to go.I just needed to make sure that the correct next hop for the dest would be the IPSEC peer, and that putting in a static route to a destination with the IPSEc peer as the next hop won't interfere with the Crypto ACl in a...
Thanks.The destination is in the Crypto ACl. The problem is that the destination network is not known in our network and the default route for other devices (not the one the crypto ACL is on) is in a different direction than towards the ISP & intern...
One of the devices is the gateway. They can ping eachother only if the 4948 is out of the picture.Show ip int brief does show it up...Interface IP-Address OK? Method Status ProtocolVlan68 8.7.70.13 ...
