Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We've got a windows server with a private 10.0.0.x address that is behind an ASA which is doing static NAT to it. I've opened up port 80 on the Fw to allow access to it but when you try accessing it, in the HTTP response it returns Content-Locati...
Hi,We have a number of Nokia E series phones that we're trying to get to work with a 1231 access point for SIP. On occasions it will associate but generally when we try to join the phone to the SSID it will crash and reboot. The AP is running c1200-k...
Hi,We have two pairs of ASA5520's, one sitting in front of the other, to create a DMZ and a Secure zone for our database servers. What is the normal practice for allowing VPN access to the Secure zone when it is behind two sets of firewalls? - Do you...
Hi,I'm after some feedback on the following configuration.On an ASA 5520 we have 3 different zones each on separate interfaces and different VLANs. If these were all connected to the same 6504 switch along with the servers would this present a securi...
Hi,It's been a while since I've done any work with a PIX and as such I'm a little rusty with them. I'm wondering if someone that's a little more familiar with them my be able to answer my question.We have a /24 block of public IP addresses that are c...
I've tried doing that, it was one of the first things I did but it doesn't improve things. Strange thing is it seems to work fine with another AP(Ruckus). It's located in an office where there are other AP's in use, ones I don't have control over.Are...
Hi, thanks for the reply.I'm not quite sure what my problem has to do with E.164 numbering, the request is destined for the wrong domain.From cisco doc http://www.cisco.com/en/US/products/sw/iosswrel/ps1839/products_feature_guide09186a0080087e88.html...
Kevin,Like I said previously, after replacing it with the 32MB AMD flash all is well. The 16MB Intel flash has been returned. I don't understand why we would of had problems with the Intel flash.Requested output is show belowROUTER#show version Cisco...
Hi Doron,Thanks for your reply. Howerver that was not my problem.I was unable to write to flash:, it didn't matter where the source was.We have since received replacement flash, 32MB with AMD chips, and is now working fine. The one that didn't work h...
Many thanks for that.I'm unsure whether it is a DSP problem...basically whats happening is that the DTMF tones are going astray when the AS5300 is busy, I'm unsure how to edit the DTMF settings on the box. So there's two things, firstly how would I b...
