Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there "standalone access point mode" -> Which means that there is NOT special / proprietary Hardware (Rack device) or Software from Cisco necessary... so i can use it just as an "normal" access point (as a bride) in EVERY (Cisco-independent) netwo...
Hi there!What kind of cable (crossed/uncrossed) and which RS232 parameters do i need for the Cisco Linksys SRW2024 Switch?https://serverfault.com/questions/299457/what-serial-cable-do-i-need-for-a-cisco-linksys-srw2024pIs it correct that there are di...
Hi there Where can i get a replacement oower supply for the AIR-CAP3702I-E-K9 access point? When i mail to Cisco Switzerland (cs-support@cisco.com), i don't get any answers. And i wrote at least 5 mails (in 3-4 weeks) but i never got an anwser. This ...
Hi there!I have some AIR-CAP3702I-E-K9 Access Points and they was in infracstructure mode. Currently, i have neither the software nor the hard to run them in infrastructure mode. Because of that, i've flased the firmware to standalone. (the firmware ...
Question in other form: Who uses that device successfully in Standalone AP Mode - with which SW version? Thanks in advance for your feedbacks!! Kind regards, Jan
OK thank you very much. But which version of then is stable ao use it in "standalone" WLAN Access Point Mode without any problems in the web GUI. (Slowness, Javascript & other code errors) Thank you very much for your feedback. Kind regards, Jan
