Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,We recently rolled out some new MR57 access points. Since we're not currently using 6Ghz I set the Flex Radio Selection to 5Ghz on the RF Profile. After setting this I noticed "Spoofed SSID's" started showing up with the MAC address of a BS...
Hi All,We only have Meraki switches in our network, but we connect directly with a partner network who doesn't.Basically two of our switches connect directly with their two of their Catalyst 3560 switches.Could these switches cause STP issues with ou...
Hi All,I was wondering what everyone does regarding Bridge priority. We have our core switch set to "0", but then I saw this document that I've linked below.https://documentation.meraki.com/MS/Port_and_VLAN_Configuration/Configuring_Spanning_Tree_on_...
Hello All,Currently we are using a single MS425 core switch to handle all our vlan interfaces and routing. We've recently installed an MX105 and have set it up as shown in the diagram. I was wondering if it is possible for the MX to handle some vlan ...
I've gone through a couple of documents for setting up AnyConnect with Azure SAML. The configuration part seemed to go fine, but when the VPN client tried to connect it returns the "cisco secure client authentication failed due to problem verifying s...
Thanks everyone for all the feedback. That's a lot of info to go through and investigate.Since we don't control or know anything about the 3560 switches, it will take some collaboration to see what is currently setup and what needs to be fixed.More i...
