Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,We have a client who is planning to switch to WebEx to handle their phone calls, and they are asking us (recording vendor) if we are able to record WebEx calls. (not meetings, but phone calls)For on premise solutions, we have been using Cisco ...
Hi all,
I have searched for topic such as the one I have, but I am still not clear on how to troubleshoot this issue, so I am hoping to get some help on this problem.
I recently installed Cisco UCM 10.5 demo license, but I have trouble registering ...
Hi all,
We just recently received a C220 M3 1.5.3b which will serve as a VM for Cisco servers. I am having trouble getting the machine to detect the hard drive I added. It is not even showing the hard drive in the boot option in BIOs. I looked at so...
Hi all,
I was able to use Cisco AnyConnect VPN to connect to the Sandbox. However, my IP address to the Sandbox was changed after I rebooted my machine. When the IP address of the machine changes, I will need to change several settings in my softwa...
Hi John, Thank you for the insight.I am looking for a recording solution to be on premise. I was reading about using a SBC such as Cisco CUBE to "fork" calls to our own recording system. Is that a feasible solution to record Cisco Webex Calling or am...
Hi all,
I am still unable to get over the hurdle of "TFTP file not found".
I have tried 8.0.(10), 8.0.(5), 8.0.(1), and 7.0.(2) of firmware from this page: https://software.cisco.com/download/release.html?mdfid=268437897&release=8.1(2)_SR2&atcFlag=N...
HI Jamie,
After turning on CUCM service, my Cisco IP Communicator and one of my 7960 phones registered successfully. However, one of my 7960 still shows TFTP File Not Found as well as both of my 7940.
I am thinking the problem has to be with the firm...
Hi Jamie,
I have DHCP (150 is set for TFTP) and DNS setup already. I also turned on TFTP on the CUCM. The last thing I did was to enable auto-registration. Those are the only things I did in an attempt to register the phones. Am I missing anything ot...
Hi Jaime,
>> 2 Look at either the device config, or the device defaults
Are you referring to Cisco UCM Administration --> Device --> Device Settings --> Device Defaults?
The Load Information for 7940 SCCP is P0030801SR02, but how do I know which ve...
