Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,
Been a while with a Cisco box and need some help refresher.
I am just trying to practice again after being away for a year. I thought that I wouldn't forget this but I guess I did.
I have a Cisco 891 and a C1111-4P (Lab units)
I can...
Hello
I am hoping I can get someone to give me advice on what model antenna or antennas to use for this application
Cisco 1532E AP
I cannot mount it in plain site and need to put in an area where I can use extended cables for the antenna. What m...
Hello
lease need some help here as I have been going in a loop here for a few days
I have a 1532i Outdoor unit trying to connect to the controller and I am getting to then point where I am getting the error
Image is not a valid IOS image arc...
HelloI am looking for some information on why I do don't see a selection for "n" Wifi in the WLAN section of the controller?I wanted to do G/N but no choice for this. Thank YouJoseph
HelloI am trying to get separate SSID's on a 2405 WLC and learned that you need to use a WLAN ID above 16.This linked helped a lothttps://community.cisco.com/t5/wireless/how-to-add-existing-ssid-to-specific-access-point/td-p/2765878 I need a controll...
Well, Well,
Of course it was my mess. I saw my error after posting sorry. I didn't rename the package file and I must have looked at that thousand times. I was concentrating on the date and not the file itself.
I got it now and thank you again
Hello,
Thank you for this, however not working for me at all.
I cannot find version 17.12(1r) so I tried without it
I do have 6.12 s
Do need to start with a different image? I have Fuji
sh version
Cisco IOS XE Software, Version 16.09.01
Cisco IOS S...
Hi Paul,
Thanks for the clarification,
I had no problem with your suggestions thank you very much. I do appreciate that.
This left me with the few questions.
What made you decide to change the ip route statement as it was being placed in by the DHCP...
Hello Paul,
Thanks alot
Thanks for the reply. I do know about the nat and non routable addresses. However didn't think I needed this on the second router as I was assuming the ISP router would handle it. SO...I suppose this needs double NAT.
Wh...