Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I would like to understand the concept of Cisco MPLS Tunnels comparing to Huawei Tunnels.Huawei way:1. User configures tunnel-interface which describes interface itself and unidirectional tunnel which starts on this interface. All attributes of the I...
Is MPLS-TE Tunnel considered as Uni- or Bidirectional ?Can the user configure MPLS-TE Tunnel in forward direction different than in backward direction ?
I have a question about MPLS Interface attributes.In the examples I see: Interface LDP Tunnel Enabled -------------------------- -------- -------- -------- POS0/4/0/0 Yes Yes Yes Interface - which ...
Just additional question: if these two MPLS-TE Tunnels are different from each other (one of the attributes bandwidth, setup or hold priority, lockdown, affinity value is different) then is it possible to route one bidirectional Pseudowire over them ...
I was rather referring to the structure of the MPLS-TE Tunnel.I mean, to configure the MPLS-TE Tunnel we need to configure the TE Tunnel Interface and this need to be done in both directions. Is it possible to configure tunnel in one direction differ...
I still don't get the difference between:LDP - State of LDP labelling.Tunnel - State of LSP Tunnel labelling. Interface POS0/4/0/0: LDP labelling enabled LSP labelling enabled (TE-Control) MPLS enabled MTU = 4474
