I would like to understand the concept of Cisco MPLS Tunnels comparing to Huawei Tunnels.
1. User configures tunnel-interface which describes interface itself and unidirectional tunnel which starts on this interface. All attributes of the Interface and Tunnel are configured here. For example bandwidth, hold priority, setup priority and especially signal type which can be rsvp-te or sr-te.
This tunnel can use one LSP (Working) or two LSPs (Working and Protection)
2. As the next step user configures kind of a tunnel trail which can be:
- unidirectional and uses one tunnel-interface
- bidirectional and uses two tunnel-interfaces in opposite directions
How is it working in Cisco ? Is there any document how to configure tunnel interface, signal type, tunnel ?
Crosswork Cloud - Crosswork Traffic Analysis - FAQ
Crosswork Cloud - Crosswork Traffic Analysis is a Cloud-hosted Software as a Service platform that provides Netflow based Traffic Analytics. The Crosswork Traffic Analysis platform Traffic Analysis, Peeri...
Cisco Champion Radio · S8|E9 Innovations to Achieve a Trustworthy Infrastructure
How do you know for certain that a router in your network has not been altered with since you deployed it? Wouldn’t it be great if you can cryptographically challenge your r...
IOS upgrade on asr9xx mandates rommon upgrades sometimes while they can be optional at other times. You may land up in unwanted situation if proper procedure is not followed during upgrades.
This article will include complete details about rommon ...
In some situation NCS560 RP become unresponsive after reload or powercycle.
In many NCS560 deployments are in remote location, deployment might be large and human intervention should be kept at minimum
Engineering team have been working on a str...
In simple terms, 'Route Churn' is defined as the 'rate of change of prefixes'. Different XR versions across 4.x to 7.x have differing behavior & support for the BGP churn handling and some enhancements made from 6.5.3 onwards (listed in appendix) mak...