Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a problem with starting the IVR. I configured my Router as in the below:!application service anons flash:/anons.tcl ! session start anons_ins anons !!dial-peer voice 27 pots service anons direct-inward-dial port 0/1/3!When I check show ...
Hi All,I've been working on an isssue but can't even understand where the problem is arising from. Please share comments.I've configured CME with voice ports as FXO. To make the IVR working, I configured the application as in below:!application servi...
Hello All,I have been working on to send CDR data from Cisco Call Manager Express (CME) to an FTP Server but it doesn't send it. I can manually copy the files to the same FTP server via the same username/password. You can find below some configuratio...
Hello Experts,I am a newby in Cisco world.My question may be a very fundamental one, but I couldn't find any reasonable and satisfactory answer in the web.One of the port on a 3750 stack that is connected to the edge switch is confıgured as in the fo...
Hi again,I am calling 02222210128 from my cell phone 0535687xxxx and I enable dialpeer inout debug. What I see on the terminal output is below. Called Number is empty and Calling number is actually what I am "calling". Do I need to talk with Telco? O...
Hi All,As mentioned in the following link (also referred by henrybb) :http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a0080093f0a.shtmlI have setup a configuration, tested and confirmed that EIGRP does not require two-way communicati...
