Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all - I had to install some new Meraki MS250 access switches over the weekend. They replaced some really old Cat 2960's. We decided to stack the Meraki switches and trunk them to the core with copper trunks spread across the stack using LACP ether...
I am trying to setup a scheduled job to copy the running config to our FTP backup server. I've managed to setup the job no problem, but looks like the switch is ignoring the FTP username and password configuration. I issued the below commands to conf...
Hi guys,
We have a whole bunch of Cisco WS-C3650-12X48UQ switches, which were shipped with a now deferred Denali IOS XE release.
Obviously we now need to upgrade. These switches were shipped with their IOS running in INSTALL mode. The upgrade proce...
Hi - I'm having problems attempting to power on the CML VM from my ESXi cluster.
I get an error that says the following: Insufficient resources to satisfy configured failover level for vSphere HA
But the error is bogus. We have enough resources lef...
Hi guys,We're in the proces of upgrading our Wireless AP's from autonomus to LWAP. We're doing the upgrades remotely (we have 100's of sites to do, and it's not possible to be there to console on to each one), using a local computer to upgrade them t...
@Mark Elsen wrote: it astonishes me that you shutdown vlan1, as usually it is a standard for carrying stp and other 'bridge managerial' stuff/protocols. I think it should not be shutdown on either platform(s). M.Thanks for the replies. Astonish is so...
@Mark Elsen wrote:2) Use core as root bridge for STP. M.This is what I'm a little stuck on. For starters I cant seem to figure out how to set the STP priority for the Catalyst 3750 core, and I've never configured MST mode spanning tree before - only...
Thank you Leo.
This wasnt very well publicised. When changing the upgrade procedure, it should be a bit less buried in the release notes!!
I will give this a try and let you know.
We're using CML 1.2 OVF, which was obtained directly from cisco.com.
Our hypervisor infrastructure has over 16 CPU's and 128GB RAM (it's a scalable blade stack). Plenty of resources there!!
As mentioned in the above post, its ESXi 5.5.0 build 17460...
