Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
New to a UCS 5108 set up by someone else. The Fans are currently running full speed. UCS Managers showed "Thermal Problems Upper Non Recoverable but all temps seem to be below 40C. In checking the web it could be an IC2 error and suggestions were t...
Hey 2811 Gurus,I have a 2811 runnung IOS Version 12.4(24)T2 with VWIC2 2MFT-T1/E1 in Slots 0 and Slot1 and am trying to add a WIC-1DSU-T1-V2 in slot 2. The Card shows up in the inventory as:WAN Interface Card - DSU/CSU T1 Fractional (V2) on Slot 0 S...
I have a PIX 315 that has our mail server on the DMZ. All internal networks are able to access the Mail server with no problem as are mail servers and mail clients on the internet. We have a remote site that connects to our internal network VIA VPN. ...
We have a remote site that needs to VPN into our network. Since the sessions they use are mostly telnet we went with a DSL line from a local ISP. For firewalling we use a PIX 506 with Ver 6.3 of the software. Our ISP provided us with a static IP for ...
I have a Cisco 1811 with Dual Wan Ethernet ports. F0 is my primary and F1 is my Backup. I used the backup interface command and it the system changes to F1 without a problem as long the F0 state is down. My problem is that F0 will be hooked to a wire...
Thanks for the reply. It looks like all the blades (5 of them) are running the same versions. Will need to dig awhile to see if these are old or not, but I am thinking they were updated to the latest version 6 months ago before the person that set th...
Your problem is probably some where in the path to you VPN end points a device is not allowing packet fragmentation.The link below explains the problem.http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a008081e621.shtmlThe...
Not seeing you config the first thing I'd suggest is look at nat exemption. If your not exempting yournew network from being natted it won't reach your remote site.
OK Sorry for the brain freeze. The WIC-1DSU-T1-V2 is programmed in the interface mode for theserial device. Seems I got lazy and forgot the service-module t1 command was in the interfacemode not at global config.
OK folks, Found the answer after several weeks of work. The DSL modem tat the ISP uses has the PPPOE location set to the DSL Modem, meaning the PPPOE username and password are stored on the modem. The DSL modem connects to the ISP, passes the usernam...
