Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Got two new AP 1200s. came with the VxWorks OS in it.Wanted to upgrade the image to IOS 12.2 JA.Downloaded the VXWORKS-to-IOS conversion image, and started upgrading the AP, via the web browser. In between the upgrade, due to a power outage, both APs...
got a leased line between two routers.End A- this end, has a wic-1dsu-T1 - configured to use all 24 channels.End B - this end has a nm-hda module with vwic-mft-2t1-DI (drop and insert) card on it. (configured with framing - esf, linecode b8zs, and co...
2691 with memory maxed out. Will it be able to handle the load of full BGP internet routing table ? I know that a min of 70 MB is needed just for holding the routing table, but want to know if the CPU is capable of handling this load, if enough memor...
Are there any potential issues configuring a vpn session between PIX and a Symantec firewall?On Symantec webpage I do see that if either one or both ends are undergoing a NAT, then the VPN negotiation doesnt take place. To get over with this, they ha...
enable netflow caching on router interfaces. You could be hit with a virus on your network. ip route-cache flow on your interfaces will enable it.use show ip cache flow to find out statistics.http://www.cisco.com/warp/public/707/cisco-sn-20030820-nac...
Is there a way to sync the images on both the bootflashes of MSFC2 on primary and secondary supervisors, using any command. I know that the Cat OS image does synchronise automatically.
You have two options, either to buy used routers, or to buy new ones.Selection of hardware - You can use a router + external CSU, or a router with inbuilt csu.You could use a router such as 1600 or 1700. with WIC-1DSU-T1 cards on them. Those have an...
Glenn,Thank you very much for the prompt response.The IOS I am using is 12.3(1a). I will upgrade the pix to 6.3(1) and let you know how it went.Meanwhile, I tried the same PIX 501 (6.2(2)) to act as a VPN hardware client, with a VPN concentrator 3000...
