Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are experiencing an interesting little problem with failover. Whilst performing some testing we discovered that when the Secondary Unit is Active, and the Primary unit is powered up, the primary unit will disrupt traffic flowing over the Secondar...
Hi All,The situation is I have one VPN concentrator (ASA5505) which is connected through to a 2811, this in turn has 4 ADSL links, there are four sites which connect in to a specific ADSL line on the 2811. I have been able to successfully configure ...
I could find a few TAC case that had a similar symptom, but all had other strange circumstances that didn't match. In the end it was an upgrade from 7.0(4) to 7.0(8) and that has resolved the issue.
Andrew,We are using the serial cable for failover signalling heartbeat.I have tried your perm fix, but I still have the same results if the Primary has a power failure.
Andrew,The three interfaces that are being monitored are all in an up/up state with IP addresses.They are also connected into a switch that has portfast enabled.The way that we have gotten round it currently is to remove the interface cables from the...
KKM,As a simplier solution to your problem, when you use the extended traceroute command, when you get to the question "Numeric display [n]: " set this to "y" and the traceroute will not try to resolve the ip address. This will hence quicken up the p...
