Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This is the first time I have setup a channel bank (Adtran TSU 600) to convert CO POTS lines to a T-1. I have normally done the opposite. In this application 24 POTS lines are coming from the CO into 24 FXO ports on the TSU 600. A T-1 Span connect...
Hello all,I have a problem which is driving me crazy. I am trying to finalize an install of an AS5300 for VoIP termination in another country. I can place calls with no problem to the local city the the PSTN (E1 CAS-R2) By stripping the city code. ...
Hello,I am setting up an AS5300 with 4 E1s. It is terminating in Iraq and I am not getting any detailed information from the Telco switch operator. Since there is no country selection for Iraq in the cas-custom settings, I am finding it hard to cho...
Hello All,I have setup an AS5300 in another country which is terminated to 4 E1s to the local Telco for VoIP. The local telco in that country is now asking for our SPC. I don't think the AS5300 will handle SS7, which is what the Telco is looking for...
Hello,I have engineers in another country installing a 4 port E1 card in an AS5300. They have installed several cards now and each one shows controller T1 in the running config. I have seen various AS5300s which display controller E1 in the configs...
Ruben,The MIBs for the concentrator is here:http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml . The link takes you to the page where you can get to all the Cisco MIBs. I found the OIDs that I wanted to monitor which were the following:....
Ruben,Is that you?? It's Javier. It's so funny that I saw our post for the concentrators we worked on because I was searching for the same MIB information and I came across your post. If I find it first I will let you know.Javier
Hello, There seems to be a bug. You can resolve the issue by copying the three .jar files in the c:\windows\java\lib folder to c:\winnt\java\lib . You can find the error by looking at your MADM logs. Search for JTAPIClientInstallException . It refere...
Hello,There seems to be a bug. You can resolve the issue by copying the three .jar files in the c:\windows\java\lib folder to c:\winnt\java\lib .You can find the error by looking at your MADM logs. Search for JTAPIClientInstallException . It refer...
I had a similar requirement for a customer and was building something along the same lines when I came across your script. It is very helpful. I had some questions regarding the variables, specifically the prompts. Could you go over a basic descri...
