Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello there,
AP registers with WLC but unable to turn on the radios, so, ssid is not showing. but works well with POE injector. given the command "power inline static max 30000" in switch(9300 PA) as well but not working. cdp and lldp are disabled ...
Dear all,
We have a requirement to deploy 8841 3pcc ip phones and we have grandstream ucm6302a. What are the requirements in this scenario. Online posts points towards templates and provisioning the phones to grandstream. Kindly help and if templates...
Dear all,we have C9500-24Y4C Datacenter switch which is about 1 year old. Lately we are getting following alert from the switch;Temp: Outlet_B R0 Normal 40 CelsiusTemp: Inlet_A R0 Minor 46 Cel...
Hi !my cisco 4221 doesn't show the ipbasek9 as permanent. Earlier it's version was 16.10.3a but downgraded to 16.9.5 Attached is the screenshot for the same. what is the process to get the license permanent as it should be there by default,i guess. ...
Thanks JpavonM,
Your recommendation worked, tried in one of the same model switch with cdp enabled in both global and interface mode. but sadly "power inline static max 30000" didn't worked.
So, it is mandatory to run either CDP or LLDP in switch, and there is no workaround? if it is so, then what are the config to be added to the switch in global mode and interface wise. first we have to try and test and then only we can raise the issue...
