Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have a Cisco ASA 5510.I have a NT Server hosting a web server setup to use the http port 10300.How can I configure my pix to allow traffic to this application from other machines in the network?My NT Server private IP is 10.0.1.25 and I'm ab...
Hi,Thanks for your reply.So I disabled all cards but the one configured as a static IP 10.0.1.25.I ran:C:\>ping Ping request could not find host . Please check the name and try again.C:\>ping 10.0.1.25Pinging 10.0.1.25 with 32 bytes of data:Reply fro...
Hi,From inside the LAN I ran Yaps which gave me the following results:Started scan10.0.1.25:10300Stopping scanI assume it means 10300 is configured properly on the server. But in this case, why wouldn't I be able to access it when I type in the url h...
Hi,b:all tests gave me an error 404 Not Found.c:I wasn't able to telnet using 10.0.1.25 from my laptop which was 10.0.1.6.I received the following results from outside:C:\>telnet 67.104.112.163 10300Connecting To 67.104.112.163...Could not open conne...
Hi,Thanks. I tried Yaps which gave me the following results from outside:67.104.112.163:80 -> www-http (World Wide Web HTTP) -> HTTP/1.1 404 Not Found..getting this resutls for port 10300 and 10500 was kind of expected, but not for port 80.when runni...
