Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm planning on upgrading the software of all our controllers from 4.2.130.0 to 4.2.176.0. The release notes state the Cisco Unified Wireless Network Controller Boot Software 4.2.112.0 ER.aes is required. Should I upgrade to 4.2.176.0 first, reboot...
One of our departments are complaining about a "slow" network from one device to another.Can you help me figure out why I'm getting input errors and CRC's?Here's the interface on the 6513:6513#sh int g9/26GigabitEthernet9/26 is up, line protocol is u...
We had a 3560 go down today. It had an err-disable on its GigabitEthernet port.This is a first. Do you guys have any clue as to why it would do this?The 6513 FastEthernet stated that it was up/up.I'm scratching my head for now...Thanks!
We upgraded our Wireless LAN Controllers from 3.2.78.4 > 3.2.195.10 > 4.1.185.0 > 4.2.99.0.We are implementing Vocera and they are requiring that we degrade the Wireless LAN Controllers to 4.2.112.0. Is it possible to degrade without losing any conf...
We have an office that has their own independent network and ISP provider in the same building where we provide network access to our remote offices. They need to access our intranet. We are thinking of running a cable from our switch to their offi...
Will do. Thanks for the input.I was in a panic mode and wanted to get the department back online ASAP.If it occurs again, I'll be sure to issue the "show interfaces status err-disabled".Thanks again!
I already put the switch online by doing a shut/no shut on the port.Here's the output of the show interface g0/3.GigabitEthernet0/3 is down, line protocol is down (err-disabled) Hardware is Gigabit Ethernet, address is 0013.1933.ef9b (bia 0013.1933....
