Hi Experts,We have the following topoly => 1 Cisco Pix 515 Version 6.3 and 3 switches C3500XL.OLD Ip address scheme:Outside: 172.16.4.1 /24inside: 172.16.1.1 /24Dmz1: 172.16.2.1 /24 Dmz2: 172.16.3.1 /24Dmz3: 172.16.5.1 /24 Dmz4: 172.16.6...
Hi Experts,Easy question, have been looking around with no luck. When I log in via SSH or telnet, how do I change the default "cisco" password in pix version 6.3?Thank you
Hello Experts I can not figure out what is the correct syntax on my acl to allow my Fa0/0 interface to receive the ip address by DHCP. My ISP is giving me the ip by DHCP and I can not get the acl correct. Has anyone configured this?Thanks, Randall
Hello Experts,I can't get my router to log or syslog to a freeware KiwiSyslog monitoring software.1- I can ping the syslog server from the router2- The KiwiSyslog logs PIX syslog with no problem3- This is the configuration I have on the router:Router...
Hello Experts,Easy questionrouter fa0/0 (outside interface)- address obtained by DHCP from ISPI need to know how I can create an acl in the outside int of the router that allows me to BLOCK all other traffic but to allow my router to continue accepti...
Jorge,I stayed up all night yesterday figuring this out and I was finally able to find the solution. This is very odd and hopefully it will be usefull for you at some point. Make sure you send a donation for the tip LOL....After indepth troubleshoo...
I appreciate your help on this matter. It is really strange behavior. Same network segment, all hosts are connected on the switches that connect to the firewall DMZ1.Can't seem to find any reason why it is not working.Best regards,Randall
Hi Davistan, Thanks for the response.1- To enable packet capture you mean a snifer like Wireshark/Ethereal?2- How do I generat a syslog message with debug from the router?I tried this command on the router and it didn't work: logging trap debug(Side ...
