Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI need to setup a VRF aware IPSec that can take requests from dynamic (unspecified) sources. This is basically like enabling a home user to connect to his MPLS VPN network with a service provider. Please help with the SP network config, not the CPE...
HiI have a setup as follPPOE client->LAC(Radius)->LNS(Radius)I face a strange issue only at the PPP authenticating phase.A snapshot of the debug PPP negotiation is as foll06:32:40: ppp67 PPP: Phase is ESTABLISHING06:32:40: ppp67 PPP: Send Message[Dyn...
I have a setup like this CE1->PE1->P1->P2->PE2->CE2. The CE and PE have ATM cards on them and the P routers are interconnected on POS with MPLS enabled on all of them. I am trying to run AToM on the PE. I see that the end to end PVC comes up and icmp...
Hi MartinThere is no specific reason for not using the aal5snap,infact i have tried this too, but the problem remains be it aal5snap or aal5mux ip. The affected traffic is any tcp traffic, or only the icmp is working.I dont see any problems in routin...
interface ATM2/0 no ip address no atm ilmi-keepaliveendCPE3700-A#sh run int atm2/0.3Building configuration...Current configuration : 137 bytes!interface ATM2/0.3 point-to-point ip address 97.97.97.2 255.255.255.0 pvc 3/300 oam-pvc manage encapsulat...
If your question is how the second preferred routing is to be done , then use a higher matric towards the ATM interface for the ADSL link. If your question is how to detect the ethernet going down , that will be either by a routing protocol or by tra...
