About philip.bonner

philip.bonner · 06-03-2007

Alright So, I am using a Cisco 871W router and currently have this config:!!!!!!!!!!!!!!!!!!!!!!!!!!!!!version 12.3no service padservice timestamps debug datetime msecservice timestamps log datetime msecno service password-encryption!hostname Router!...

philip.bonner · 05-13-2007

Hello Everyone, First off I want to say this is my first time posting so sorry if I mess something up. I am just beginning, I have purchased a Cisco 871W router and trying to solve a problem. How my current network is set up I have a Network A: 192.1...

philip.bonner · 05-14-2007

The problem is Router A can not change, no matter what. So that there presents a problem. If it could change then I would expand the subnet to allow the static addresses. Basically creating two subnets in one.

philip.bonner · 05-14-2007

Thank you for answering my question, the only problem is that situation wont work, Network A has to be Independent of Network B. So Router B could not issue the DCHP addresses. It has to be in a way that if we randomly remove Router B everything stil...

philip.bonner · 05-14-2007

I want it to be that if Router B gives out an IP address that it will request an IP address from Router A to use for a direct one to one Ratio. So Router B gives out an IP address of 10.47.1.4 I then want Router B to ask Router A for an IP Address an...

philip.bonner · 05-14-2007

Internet ->Cable Modem->[WAN]Router A[LAN]-> [Network A] Computer A Switch A Computer B [Wan]Router B[LAN]-> [Network B] Computer C Computer DNetwork B is mainly used as a testing network and so it will never have over 50 computers. The reason I ...

Member Since	‎11-01-2006 08:25 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	7

User Statistics

User Activity

Non Bridge Interface will not work

Dynamic Nat

Re: Dynamic Nat

Re: Dynamic Nat

Re: Dynamic Nat

Re: Dynamic Nat