Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day, I seem to have an issue with the routing/NAT. In my virtual test lab I have traffic that is not able to go out to the internet.From the sw06 it goes to a Palo Alto in vWire mode to the edge router R10. This node has a dhcp interface towar...
Hi, I want to offer my gratitude to everyone that offered their feedback. The solution was in 3 parts:1) the default route had to be interface and next hop on both r6 and r10,2) the DHCP interface on R10 was redone as a static IP,3) on the cisco 375...
It was very helpful but I still cannot get to the internet via any of the host on R6. I didn't want to use a double NAT as it has been known to cause issues. When I traceroute from my wifi connection I see 3 RFC1918 before a routable address appears....
Hello Guys, I cannot thank you all enough for sticking with me on this issue. If I was miscommunicating with any of you please feel free to drop some feedback on improving my communication to the community. I have uploaded another diagram with more...
hi, I originally started with the default route to dhcp (ip route 0.0.0.0 0.0.0.0 dhcp) and I had played around with it a few times to see if it will work. currently on my R10 router i have it set to 'ip route 0.0.0.0 0.0.0.0 ethernet0/0 dhcp. I beli...
