Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to use EEM to send an email containing a simple message when a track goes down, on switch nexus 7kHowever, when configuring the actions of the event manager, I do not find the "mail to" option. When do I write "?" after the action, I have ...
On my nexus 7k, I'm trying to create an ip sla reachability, and insert it into a vrf However, when I try to insert the track into the VRF, I get the following error ip sla 491icmp-echo 8.8.8.8 source-ip "default gateway"vrf EXEMPLE_VRFthreshold 400f...
I am trying to deploy VPC in my scenario. I already own my vlans normally. What was not clear to me is, when I implement VPC, should I recreate my entire vlan environment, or will my existing vlan become VPC VLANs? Additionally, can I put my peer lin...
I've seen this threadBut, the answer that was dated in this question, is using exactly the feature that is not available, that would beR1 (config-applet) #action 4.0 mail server "11.0.0.2" to "Mithun.adhikary@dimensiondata.com" from "eem@cisco.com" s...
I need the tracker to monitor an IP SLAHowever, when I place this track inside a VRF, a VRF does not accept it, because it is an IP SLA type track, and not an IP Route type.I'm not sure if the IP Route type path will help me help
Thanks for the supportI'm trying to track using metrics, like thresholdSo that the track stays down in case you have a lot of packet loss, for example, so the configuration you passed does not resolveBut in the document you passed it has a shape, I'm...
Thanks, that was exactly my question, if I needed to do any additional config. So, just by activating my peer-link, which is always a trunk, are my vlans already "vpc vlans"?
