Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So i do not know why this is happening and i think the configuration is correct but basically im prepending as path to a prefix and it doesn show up in the next directly connected router which is a bgp neighbor. Same issue persists on both vios route...
So in prod we have 3.3On 3.3 (this was upgraded all the way from 2.x) we can see this attribute shown below-Mode#OpenI do not see this however in the 3.4 image that i am using in my eve-ng lab (90 day trial license).There is also "Mode#Closed" attrib...
Hello all, so im running cisco ise 3.4 on my eve ng lab, im using cisco vios switch image and ios-xe router image.i am able to login as different users, no issues with full access according to whats allowed in the rule.But the issue is when i try to ...
So i have the following topology-ISP-RT-1 has a default route pointing to 192.168.20.1Image being used is - vios-adventerprise9-m.SPA.159-3.M6Some show commands-ISP-RT-1#show ip bgp 0.0.0.0BGP routing table entry for 0.0.0.0/0, version 2Paths: (1 ava...
So ive been completely stumped for a few months now regarding this issue, i have a lab running on eve ng with nexus 9k images and this happens regardless of the version, ive used 9500 images, 9300 images and different versions of each and i still get...
Ah I see, sorry I guess I didn't read your first reply properly, I will try this out soon and if it works I'll mark your reply as the solution. And thanks for your quick replies.
Sorry it was a typo, I meant 11.2.101.0/24So as you can see for 11.2.101.0/24 it does not get prepended in the show ip bgp (just below the bold line).Do you know why?
So i created the mode with open and closed which looks exactly the same as prod but now when i try to get a win 11 pc to auth on the port on the switch it doesnt hit the rule since this is what it shows for the attribute-Mode#ModeInstead of say-Mode#...
that was a quick reply!ok i will try creating these attributes just like you suggested.ok noted that the names should be the exact same.Once again thanks for the absolutely quick relply!!
