Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Guys,I have an issue and i need your help if possible.I have 6 cisco Switches 2960 48 port and one 3750 core switch, one of the edge switches damaged i think the motherboard is corrupted.Somehow i need to replace it with SG220-50-K9-EU .. Is t...
Hello Guys,I can't access web GUI for cisco switch ,However I can access it via SSH and telnet.my credential didn't accepted. Running Configuration is attached.
Hello Guys,I have 3750x-48 Switch, I created DHCP Pool for Wireless Access Point VLAN as below:ip dhcp pool WAPnetwork 10.80.0.0 255.255.248.0default-router 10.80.7.254dns-server 8.8.8.8ip dhcp excluded-address 10.80.0.1 10.80.0.15 I want DHCP IP add...
HelloI have ws-c3750x-48 core switch. All i need is that all Vlans on my network can access internet, I connected FortiGate to interface 1 on core switch Fortigate Lan interface ip is 10.0.0.1/24when i assign interface 1 on core switch as a trunk int...
Hello,I need your helpInter-vlan routing doesn't working on the C3750E SwitchI need to route between vlans for ex: vlan 5 and vlan 10 as shown belowip routing enabled a vlan 5 hosts can't communicate with vlan 10 hosts although each of them can reach...
i did the following:On Core switch interface GigabitEthernet7/0/48switchport trunk encapsulation dot1qswitchport mode trunk New Switch: No pvst mode Third-F-Edge(config)#spanning-tree modemstp Configure IEEE 802.1S Multiple Spanning Tree Protocolr...
I have already trying to connect the SG220-50-K9-EU to the core switch with the same needed setting different way as no vtp mode on this model.but didn't work ... VLANs can't reach each other core and new switch configuration attached.Note: The two s...
