Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We will be changing the route reflector server location from one site to another. Hence, I also need to move the loopback IP from one site to another. By doing this, I need to update all the clients (they all have peering with the RR loopback IP's...
Hi Everyone, I have recently upgraded the switch onto new version and leave the old os. Now the switch is running with just 17mb space left in flash. I prefer to leave old software just in case if I want to go back but then space matters so would be...
Hi, I am finding a hard time finding ISO version compatibility. Can I go from current running ISO version: 15.0(2)SE6, 15.0(2a)EX5, 15.0(2)SE8, 15.0(2)SE8 TO 15.2.4E8 MD? Switch models: 2960-C and 2960-X (24 & 48 ports). Thank you.
Hi, I am trying to telnet, SSH from PC to switch but not able to access it. Following is the switch config: Switch>enPassword:Switch#Switch#show runnBuilding configuration... Current configuration : 779 bytes!version 12.1no service timestamps log dat...
Hi,
The two switche, namely A and B are connected with a single link and both switches have few vlan's.
here, Can I still make the switch A as the root bridge for specific vlan's that are associated with Switch B ?
I would like to know, is there an...
Thanks all for your valuable input, appreciated. I will check whether GR is enabled or not in all clients. All clients/peers currently have access to the RR servers at both the PROD and DR locations. The PROD RR server is presently the central point ...
Hi All, Thanks for your suggestions. The switches are running with free memory space, just 25% used of total memory allocation so I have decided to leave old software for some time just to check how switches are behaving with the new OS. Regards,Chi...
Hi Priyanka, Thanks for your prompt reply. I have successfully upgraded the 2960X stacks through "archive download-sw" command. Big thanks to Leo Laohoo. Regards,Chirag
