Hello, I'm trying to setup hsrp within a C3560E-48TD in a interface vlan, but it does not accept my command.Could someone help? The output is below SWACC06-LI2(config)#sdm prefer dual-ipv4-and-ipv6 defaultinterface Vlan700
ip address 179.60.151.3 2...
Hello guys, I'm receiving this error when I try to add 2 40G interfaces in a Port-channel SWACC10-DA2(config-if-range)# no speedSWACC10-DA2(config-if-range)# channel-group 1 mode activecommand failed: port not compatible [Capabilities speed]Switch...
Tks Balaji, it worked I add the ports separately. Now I can't add the speed to the Port-channel. SWACC10-DA2(config-if)# speed 40000
ERROR: port-channel1: requested config change not allowed
