Hello,
I'm trying to setup hsrp within a C3560E-48TD in a interface vlan, but it does not accept my command.
Could someone help? The output is below
SWACC06-LI2(config)#sdm prefer dual-ipv4-and-ipv6 default
interface Vlan700
ip address 179.60.151.3 255.255.255.0
no ip redirects
ipv6 address 2803:C560:E000::3/36
standby version 2
standby 10 ip 179.60.151.1
end
SWACC06-LI2(config-if)# standby 15 ipv6 2803:C560:E000::1/36
^
% Invalid input detected at '^' marker.
SWACC06-LI2(config-if)# standby 15 ipv6 2803:C560:E000::1
% Invalid link-local address