Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The SG500X models do support three speeds. The base models have 1Gig/5Gig (Copper/SFP) combo, while the SG500X models have the extra 10Gig SFP slots for those who require the extra speed. However, note that these 10Gig SFPs are not exclusively for st...
Hello Everyone,In case you haven't seen them yet, Cisco has come out with a new line of stackable (not just clustering ), managed small business switches:http://www.cisco.com/cisco/web/solutions/small_business/products/routers_switches/500_series_sw...
Hello,I'm not exactly sure what the question is. Are you asking how you can minimize the differences in the outside IP address?If that's the case, you might remember that the following statement doesn't use PAT. It will translate one host per outside...
Hello Jack,Do you have any DMZ access-rules at all? If so, what are they? Also, what are the security levels of the inside and the DMZ? Are you using a "same-security traffic" command anywhere?Thanks!Joey
Did you also add the access-list and access-group? You have ACLs but they aren't grouped to any interface.ex (per your static):access-list outside_access_in permit ip any host 152.18.75.133access-group outside_access_in in interface outsideI'm not su...
