Hi,
During audit in my company network scan revealed open port TCP9067 on Cisco ISR 3925 device. Do you have any idea what for this ports is used? I spent hours of googling but with no luck.
Regards,
Lukasz
Hi All,
During audit in my company network scan revealed lot of open ports on Cisco AS5400XM device. These are few TCP ranges:
2216-23832432-27552416-43834432-47556216-63836432-67559216-93839432-9755
We have few devices on on each device range is s...
Hi,I have some problem with ipsec configuration. Here is a topology:I want to create VPNs between LANs so i started co configure vpn from LAN1 to LAN3. The problem is that packets are encrypted only when source (and/or destination) address of ping is...
Matt, thank you for response. You're right, port showed up in output of "show control-plane host open-ports" but timeout was very short and that's why I didn't noticed it. Unfortunately it's not telling me much:
Prot Local Address ...
Thank you for command however I found strange behaviour of cisco router. Scan found few ports opened on device: above mentioned tcp9067 but also tcp2067 - Data-Link Switchingtcp4067 - Information Distribution Protocoltcp6067 - SRB (source-route bridg...
Thank you for the reply!Now ive done this, but it still doesnt work. When im changing ACL, to make it faster im doing it in cfg file, and then reload the router, so i think, all SA are cleared anyway ?
Thank you for the reply!Unfortunately, i've tried a lot of acl, also the one you have suggest and it still doesnt work.I also tried acl:R1:access-list 102 permit ip host 80.0.0.2 host 80.0.0.130R8:access-list 102 permit ip host 80.0.0.130 host 80.0.0...