Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 6509 with a router module installed. On this router I have multiple vlan interfaces one for each subnet. I am adding a new subnet which I want to isolate except for outbound Internet access and specified functions between the subnets.the sub...
I have a subnet of 10.31.2.x with a mask of 24. The servers I want to control access to are in the range 10.31.2.71 through 77. Will the folowing statement allow http to these servers.Permit tcp any 10.31.2.64 0.0.0.15 eq 80Thanks
Have been given a network where one of the subnets is 27.0.0.0/8. However many of the servers that I want to control access to have addresses of 27.200.1.x. Even though the subnet has an 8 bit mask can I write an access list linepermit ip any 27.20...
This is my first attempt at wireless other than static wep key. I have set my 1130 ag as having a local radius server, including groups, users and ssids. I am having trouble getting the access point to use the local radius server. When I try to conne...
A 2851 router serves as an end point for an IPSEC vpn between to sites. I would like to now also allow users behind this router to access the Internet. Do I need an additional public ip address or can I hide behind the same IP?
currently using dhcp to obtain ipsh intBVI1 is up, line protocol is up Hardware is BVI, address is 001e.f7ef.03ee (bia 0022.550d.0cf0) Internet address is 27.101.1.5/8 MTU 1500 bytes, BW 54000 Kbit, DLY 5000 usec, reliability 255/255, txload...
I made the changes and still am unable to connect new configCurrent configuration : 2276 bytes!version 12.4no service padservice timestamps debug datetime msecservice timestamps log datetime msecservice password-encryption!hostname APTEST5!enable sec...
I tried following the steps in this doc and still receive an error on the client that the 802.1x authentication server is not availableHeres a copy of my configCurrent configuration : 2085 bytes!version 12.4no service padservice timestamps debug date...
