Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi!I have problem to get multicast working on my CBS350-24FP-4X. I made it according Cisco`s youtube video CBS Switch Multicast Forwarding Using IGMP Snooping. Only thing that differs is that I changed interface default settings (ports and VLAN) to v...
Hi!I got three Cisco SG350 switches connected together via trunk ports and has two VLANS (10 and 20). 28 port version has four trunk ports (two RJ45 and two SFP module slots) and those have been connected to those 10 port versions trunk ports. Now I ...
Hi! I have problem with IGMP querier config. I would like to change version 2, what 3560 uses default, to version 3. Reference guide says that go interfaces config and then type command ”ip igmp version 3”. After that I could config other parameters,...
Hi! I got newbie question and I`m not sure if it´s imbossible to do. But situation is this as described below. I´m doing this outside broadcast AoIP based system, which includes few switches and mobile router. I have Cisco SG350-28P switch and it´s r...
Hi!I have purchased used 3560-CX and I´m trying to enter express mode to start configuration of particular switch. Problem is that when I hold down mode button about three seconds, all light`s (texts) turn green and then I release it. It seems to sta...
I just noticed that ports 25/26 have switchport access vlan 20 (those port do not work properly). And ports 27/28 have switchport access vlan 10 (these work as they should). Could that be the fault?
Hi! Thank you for advice. I tried it earlier, but then everything stopped working, so I returned previous state of things. Now I tried it again and after that noticed that trunk ports changed into access ports. I changed them back to trunks. Now DHCP...
Hi! Thanks for your answer. There is four SFP slots and two of those are those kind of dual personality ports and other two are only SFP ports without copper next to it. So that should not be the case.
Hi! Sorry that my response is little slow. I`m sound technician that has basic education of IT-sort of things and trying to gain more knowledge about these things and I´ve been doing production and not been at the office for a while. But that is enou...
It seem´s that device does not have settings that I was hoping for. I have search through manuals and did not find solution. I was hoping to achieve this by using equipment that we already have.
