About stefan.jones

stefan.jones · 02-09-2007

Hopefully a quick question, but one that is hard to answer by reading configuration guides without better knowing what to look for.I have an EVM-HD connected up to some analog phones. Whenever one of the analog phones are answered, the router makes ...

stefan.jones · 09-01-2007

Install SDM and use the remote access VPN wizard, that's going to be the simplest way.Lots of docs.http://www.cisco.com/en/US/products/ps6659/products_ios_protocol_option_home.html

stefan.jones · 04-20-2007

What's a 2818?The ISRs , such as the 2851 support bridging via BVIs and VLANs, and ones with NM slots can have additional switch modules installed (for a serious chunk of change). You want an ASA5505. It has an 8 port switch built in and is the rep...

stefan.jones · 04-17-2007

Someday we'll see Virtual Tunnel Interfaces on the security platforms. Then DMVPN would be all you have to set up. PIX 7 supports redundancy on a vpn group. I would guess it would work with IOS, though I've never tried. Plus if your IOS is new en...

stefan.jones · 04-17-2007

I've seen WebSense on a LAN only, but I've used SurfControl with local databases and integrated into non-Cisco products. Integrated filtering uses an Internet server for URL filter, so it similar to using a WAN or VPN.Websense on the LAN didn't slow...

stefan.jones · 04-15-2007

I think the NAT overload is still affecting this traffic from mobile user to mobile user. This traffic still goes through the Dialer interface both ways.This is definitely the case if you see receive errors incrementing on the client statistics.Make...

Member Since	‎11-21-2006 03:00 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	16
Total Helpful Votes Received	9

User Statistics

User Activity

Disable connection dialing noise when answering FXS

Re: configuring 2821 as vpn server

Re: PIX to ISR

Re: 2811 Router - Dual ISP using OER?

Re: IOS URL Filtering (FW Feature Set - Websense)

Re: Cisco Router - Dynamic IPSec VPN Clients cannot communicate