Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am working on QoS exam for CCIP and I have the following question:What is the difference between:shape peak 64000andshape average 128000 8000 0In both cases, the traffic rate will be about 128kbps right ?Thank you !
Hello,I use two 7600 as P routers.These are configured with routed interfaces:interface Gi2/1 mtu 1520interface Gi2/1.15 no switchport ip address 1.2.3.4 255.255.255.0 mpls ipNow want to use SVI:vlan 1145 mtu 1520!interface vlan 1145 ip address 1.2.3...
Hello,I am working on BSCI, OSPF part.I see a command to summarize:area area-id range address mask [advertise | not-advertise] [cost cost]In fact, I don't understand the utility of the 'not-advertise' option (I just see that type 3 LSAs are suppresed...
Hello everybody,I have many networks that I need to NAT.I don't know exactly what are these networks so, I tried to nat with an 'any' statment in my ACL.But, it doesn't works (http://www.cisco.com/warp/public/556/nat-faq.html#qa39)So I am looking to ...
Hi,I use cisco vpn client with a 7206VXR.I have configured an ''ip local pool'' which gives us ip address for each connected client.The pool is configured like this:ip local pool Pool-Z 10.3.1.1 10.3.1.254and we use it like that:crypto isakmp client ...
Hello,Yes, I tried this statement and it works but I hope I will not have 'unexpected behavior' has said in http://www.cisco.com/warp/public/556/nat-faq.html#qa39Thanks
Yes, but it will become an any any statment:ip access-list standard 10permit 0.0.0.0 255.255.255.255s ip access-lists 10Standard IP access list 10 permit any:(
