Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Like in the title I have an ISR1100 Router with 8 port switch and an additional 2 x LAN/WAN GigEth ports.I have 8 devices connected to the switch, and a WAN connected to one of the LAN/WAN ports, leaving 1 LAN/WAN ports free.I would like to trunk tha...
It's been 10 years since I've worked with IOS so I'm back to being a beginner and would really appreciate any advice you can offer to help with the issue - "not routing to the internet" Network setup is: 1 VLAN for internal services (101) associated ...
Yes sorry about the confusion. The port I'd like to use is GE0/0/1 - the LAN/WAN port. This is simply because all the switch ports are currently in use. But I'm guessing that's not possible? If there's no way to achieve this with the LAN/WAN port, I'...
Thanks Jon.I thought that's what I might have to do. Since the switch already has 8 devices connected, was hoping I could do it using the WAN/LAN port.I'll see if Balaji has any suggestions, in the mean time I'll see what device they are happy to rem...
I'm not sure what language to use to describe it.What I want is essentially extend the existing vlans on the ISR to the Catalyst 3560.ie. I want anything connected to a vlan101 port on the ISR to be able to send and receive data from anything connect...
Hi Balaji,I got another step. Not sure why I couldn't create the sub-interface last night. I ended up adding it in the webui then I could use it in the CLI. regardless.On the router...interface GigabitEthernet0/0/1 description Trunk to Switch no ip a...
Hi Jon,Thanks for your reply.As I mentioned in the original post, that interface doesn't respond to switchport. That's where my issue started router(config)#int GigabitEthernet 0/0/1router(config-if)#switchport ?% Unrecognized commandTo clarify, yo...
