Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,The note is from Cisco switch STIG requirement that I need to implement in all my switches in the network. Rule Title: The Cisco switch must have all disabled switch ports assigned to an unused VLAN.Discussion: It is possible that a disabled p...
Hi All,I wanted to configure the NTP server in our network. The network is isolated from any outside connection. No router. Can I set up one of the switches as an NTP server and the other will sync with that switch?Thanks, Yared.
Hi All,I recently have an issue with some of the switches lost the VLAN connection after the switch reload. sh int command showed interface down and protocol down. I have to assign the VLAN after reboot. any idea why the switch lost its VLAN?Thanks,
Hi All,I have 2960 Cisco switch. After I turn the switch off and back on and I get the "Would you like to enter the initial configuration dialog? [yes/no]: " message again and the config is lost.Please any suggestion would be appreciated.Thanks,Yared...
Hi All,I have to reassign a port for a Vlan for a couple of 2960 and 3850 switches because it drops the port every time I reload the switches. Please, any suggestion to fix this would be appreciated.Yared.
Hello Sorry for the late reply. The port VLAN assign disappear after the switch reboot. I have to run SW#switchport access vlan 999 command on that port
Hi All,I ended up copying the backup configuration file and now everything works. But I still don't know the reason why this happened in the first place. Thank you all.
