Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,My NMS send SNMP time out message from the host which is in a diffrent VLAN other than the NMS.I did't find anything wrong in my network and it seems to be no delay between these two.Please help me how to find out the resoluation for this issue.FY...
Hi,My 7609 router has 2 no of sup720.But only one is active,the other one is not in redundant state.Says it is disabled.I connected the console to the second SUP720 , but it is in rommon mode.How can I go forward.It is in a live environment so I have...
Hi,I have configured jumbo frames sized as 9198 in a 4948 switch using interface config mode inc the ether channel configured as trunk port.But after 10 min the switch stopped forwarding the frames.I would like to know is it possible to pass jumbo fr...
Hi,I would like to know , up to how many no of 10 gig port a module can support for 6500 series switch.I heard that max will be 8 no of 10 Gig port available.Sup 720 is enough to handle these much of traffic , as backplane or it will create any bottl...
Hi Abhishek,There is no access list and no firewall in between these two.Alos cheked the community string it is same and it is working some time and goes off some time. I am not sure that it is the network issue.It may be the SNMP server and host iss...
Hi,There is no access list and I am not sure that it is the network issue.It may be the SNMP server and host issue.But I have to make it confirmed that the netowork is fine .All the networking devices in between these two are having the basic config ...
Hi Ankur,I think I configured jumbo frames only in the port channel.Not in the corresponding member physical interface.I have to check this out.Thank you for the response you have given.Anil.
Hi Ankur,Thank you for the reply.I have conbfigured in all the port , but using the interface config mode using the range command.Alos configured the uplink port which is an ether channel trunk port.But after doing this I can't able to ping to outsid...
