Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI'm trying to configure my Cisco 5585-X. In ASA module I'm able to see all interfaces but I can't configure any of them in terms of setting up IP address - this option is simply not listed there in config interface.Am I doing something wrong? Also,...
Hi Guys, I have a very basic Cisco switch WS-C2960-8TC-L. I wonder if it is possible to have intervlan switching enabled on it? I know this is L2 switch, but since it doesn't have a fan it's not noisy and I can keep it on my desk.I can configure VLA...
Hi Guys, I have created a 3x VLANs on C3560. I have configured 'ip routing' and needed interfaces. I have access to the internet and I can try ping hosts in the other vlans, however I get response from them only if I add a route manually on each host...
Hi, I'm trying to create a lab with 2x 5506-X FWs and add them to the FMC. However initial configuration after FW reset doesn't allow me to choose 'Managed locally?' and set in to 'NO'. Therefore i can't use command 'Configure manager add xxx' - this...
Many thanks Marvin! That was it. I have been using Java Configuration console to add an exception, and I have also removed TLSv1 and TLSv1.1 from the mentioned config file - that didn't help..What I have done was, I have connected to the other FW to ...
HiThat was it! Thanks very much!I have changed my response as after adding name to the interface it started responding to ping. Now I can try to connect to it via ASDM, but now the TLS 1.0 is a problem I need to convince Java to trust it... I have a...
HiMany thanks for your response Here is the configuration:ciscoasa# show running-config
: Saved
:
ASA Version 9.1(3) <system>
!
hostname ciscoasa
enable password 8Ry2YjIyt7RRXU24 encrypted
no mac-address auto
!
interface GigabitEthernet0/0
shutdown...
Hi Marvin,I am aware it is EOL for long time, but it is exciting to make it work. This is like classic Bentley :-), but it will be used in the lab only.I will try to play with its context and modes. Maybe that will help.If you have any other ideas pl...
HiThanks for your answer. There must be something else as the result I'm getting is:ciscoasa# conf t
ciscoasa(config)# int M
ciscoasa(config)# int Management 0/0
ciscoasa(config-if)# nameif management
^
ERROR: % Invalid input de...
