Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi lads,I had a strange failure scenario in one of my customer networks. I'm wondering if someone couldn't answer my questions.Given the following network layout:- Router A1 & A2 - runnning HSRP (vlan100 - 192.168.100.1 / vlan 66 - 192.168.66.1) A1 ...
Hi,it´s a little bit confused ! What´s the difference between Int 2/2 and 2/3 ??best regards! Cat WS-C4506; IOS Version 12.1(19)EW1; SupIV WS-X4515Module2 18Port GigaBit WS-X4418-GBC4506(config)int gig 2/2C4506(config-if)#switchport trunk encapsulati...
Hi,I have a problem with a Cisco Aironet 350 workgroup bridge v8.84. After a reboot of the bridge or. pull out/put in of the ethernet cable the client connected to the ethernet port lose his network connection. After that, a reset of the radio interf...
Hi,I have a question about best practice about the "rts threshold". The default value of the rts threshold is 2312, so by a mtu of 1500, clients never send a request-to-send, i.e. rts is disabled per default. I have tested it with a ftp download with...
Hi, does anyone knows what the SNAP Type 010b is and for what this packets are used ? THX Larry DLC: ----- DLC Header ----- DLC: DLC: Frame 18 arrived at 08:57:31.0333; frame size is 64 (0040 hex) bytes. DLC: Destination = Multicast 01000CCCCCCD DLC:...
The problem is that there are no difference between the two interfaces, but at port 3 I can´t enter the command "switchport trunk encapsulation dot1q" > "% Invalid input detected at '^' marker" and at port 2 I can enter it normally. However the confi...
Hi,this config should work. Note, that you also need BVI 1 for wlccp. I had make many tests with another BVI as BVI 1 and I can´t recommend it. The AP crashed very often or. needed a reload after the configuration of a new feature.version 12.2no serv...
The error message only occurs three times, shown above. As I can guarantee, there is no hardware defect and the maschine doesn´t crash in productive time ?
