Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI'm developping third party recording application through JTAPI interface.i'm running a collaboration lab 10.5, i have 3 externals Cisco 6941 SCCP phones.All 3 phones are registered and i can dial between them.The only softkeys available are redia...
HiI re-started a collaboration 10.5 lab for the whole week (i couldn't extend on friday the lab i had last week time limit exceeded too bad)Last week i was on rave09 and changing the VPN connection with FREEABCGROUP9 worked straightfully.I modified ...
HiThe sandbox connection login page returns a service unavailable error when entering wrong login with right password.Right login with wrong pasword gives back correct error message.Alain
HiWe need to make some recording tests using external devices cisco phones 6941.In the documents we need to use an ipsec router- loan a pre configured one from cisco (could'nt find any estimated delivery time)- or use another ipsec routerDoes anyone ...
Hii already used a collaboration 9.1 dev lab to make some tests without any problems.This time the CUCM machine has no ip available (NA displayed)setup was completed.web access gives a na/ page which of course fails to load.i tried to rerun setup com...
Hish cry isa64.103.37.21 xxx.xxx.xxx.xxx QM_IDLE 2952 ACTIVE (with GROUP8)#ping 10.10.20.1 source vlan1Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 10.10.20.1, timeout is 2 seconds:Packet sent with a source addres...
Hisorry that it was unclear.I'm able to log in.I thought the dev lab was in maintenance for some time (due to the error message) so i tried over time to re login without checking the credentials,I have no issue at the moment, it is just to prevent so...
