Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello-I have an ASA 5510 device mounted in an APC rack with the face-plate forward so that the network cables plug into the back. It appears to me that the front of the device has both an intake fan and an exhaust fan all in the front. Most if not al...
I have a asa5510 and when I scp from the VPN client to an inside server the transfer starts and slowly drops in speed until I see a stalled message.Everywhere I read suggests it is the df-bit problem. I tried to set the df-bit to clear globally with:...
I have a asa5510 and when I scp from the VPN client to an inside server the transfer starts and slowly drops in speed until I see a stalled message.Everywhere I read suggests it is the df-bit problem. I tried to set the df-bit to clear globally with:...
Hello,I have an asa5510 as my default router. On the inside (100M) interface, I have defined one network that uses the default vlan 1 id and another network that uses vlan 10, both with named interfaces. The inside interface cat6 cable is physically ...
I cannot ssh into my asa 5510. All required steps have been taken. Am I missing something? I can asdm and telent into just fine.Cisco Adaptive Security Appliance Software Version 7.1(2) Device Manager Version 5.1(2)Thanks for any help!
This works for the startup config; however, when you view the running config the same WebVPN attributes show up. It's strange, the startup config does not show them but the running config does.Thanks
When I go into the asdm to disable management on the interface, the checkbox: "Dedicate this interface to management only" is greyed out and unavailable. I tried it through the cli as well but it said that, "management-access not enabled on interface...
I currently have the ASA5510 setup using the physical inside interface (10.0.1.X) and a VLAN inside subinterface (192.168.0.X) network. I VPN into the ASA5510 to access both networks on the inside interface. I want to move the (10.0.1.X) network to t...
