About john_of_rohanne

john_of_rohanne · 09-14-2021

Hi, I've been asked to source an AP for an ATEX environment. The AP specifically needs to be Zone 22, which I believe is Class 2 Zone 2. I'm quite new with installing an AP in an ATEX environment, but I'm struggling to find an AP that isn't Class 1 Z...

john_of_rohanne · 08-25-2021

I'm quite new when it comes to Mesh Access Points, especially when using them with standard Access Points. We have an area onsite whereby at the bottom of the yard we have a root access point on the corner of the shed, and two Mesh access points near...

john_of_rohanne · 08-16-2021

What would cause a C9500-16X (or any Cat9k) switch to default to the ROMMON configuration mode? The switch itself had the IOS on the switch, it just required to be manually pushed through. During the day we had a fibre break, but this link was only r...

john_of_rohanne · 09-15-2021

Seems that the enclosure is the way forward for this one. Thanks for sharing.

john_of_rohanne · 08-30-2021

Later investigations found that the 5GHz wasn't broadcasting and 2.4GHz is on a low power level due to the amount of interference it can see. Took a bit of time to find this issue, but your messages definitely helped with my investigations.

john_of_rohanne · 08-16-2021

Hi Leo, Thanks for responding! I think I found my answer by following your commands. The switch was rebooted which explains how it got into that mode and there is a boot order, but only for the one switch. We have two switches stacked via SVL. I thin...

Member Since	‎04-08-2021 07:39 AM
Date Last Visited	‎10-22-2021 12:04 AM
Posts	6

User Statistics

User Activity

Class 2 Zone 2 suggestions for Wireless Access Points

Roaming and association issue on Wireless

C9500-16X default to ROMMON mode

Re: Class 2 Zone 2 suggestions for Wireless Access Points

Re: Roaming and association issue on Wireless

Re: C9500-16X default to ROMMON mode