Configured vPC on my Nexus 3132Q.Now I want to connect a server host with redundant to it.In the server are 2 Mellanox ConnectX3 dual 40Gbit cards installed.All 4 ports have been added to a SET(Switch EmbeddedTeaming).Now do I connect 2 cables to eac...
Hello everyone.I have a problem again.I just set up my HyperV CLuster.Cluster consists of: 3 HP DL360p G8 each with 2 Intel Xeon 2660 V2 10 Core and 64GB RAM.Each server has a Mellanox ConnectX3 Dual 10Gbit network card installed and a second 10Gbit ...
I have a problem with my Nexus 5548UP.The data transfer between 2 Vlan's is very slow.Data transfer in same vlan's is ok.Have installed a L3 card and a LAN_ENTERPRISE_LICENSEInter-Vlan routing works.See pictures: Here is a PC in vlan 30 with 10Gbit S...
Hello, I have a small problem with the Nexus 5548UP.Have created vlan's and the vlan interfaces.I can ping the interfaces. Works.Ping from windows host to all vlan interfaces Works.Pinging from windows host in vlan 10 to windows host in vlan 20 does ...
Hello, I am looking for a used Cisco Layer 3 switch. Up to 350 euros. Might bid for a Nexus N5K-C5548P. Unfortunately, it does not state whether a daughter board is installed.The switch should have sfp + port.Do you have an idea?
Now a Switch Embedded Teaming is always Active/ActiveIf I just connect the server to the switches, without portchannel, then I don't get load balancing either, right? I would like to achieve that a load balancing takes place.Will this work if I put t...
