Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have PAT setup on a 6509 for address translation. I have someone that wants to connect to a VPN server across the Internet using Microsoft's PPTP client.So far the connections are failing. I am pretty sure it can be fixed by using a Static address,...
Hi all, We are running into a problem with channel changes on and IPTV network. Each channel is a mulicast address. I have two 6509 switches, each running 12.2(18)SXF3 Switch 1 (S1) has the multicast source located on it. Switch 2 (S2) has our custom...
Hi all,We are running into a problem with channel changes on and IPTV network. Each channel is a mulicast address.I have two 6509 switches, each running 12.2(18)SXF3Switch 1 (S1) has the multicast source located on it. Switch 2 (S2) has our customers...
Hi all, I have the following problem.. I have a cisco 6509 switch which 4 networks are connected to it.. 172.20.2.0 172.20.3.0 172.20.4.0 172.20.200.0 the default routed is pointed to our ISP's router. We are using NAT for address translation for the...
Hi all,I have the following problem..I have a cisco 6509 switch which 4 networks are connected to it..172.20.2.0172.20.3.0172.20.4.0172.20.200.0the default routed is pointed to our ISP's router. We are using NAT for address translation for these rang...
Ya,I had tried that, and yes it did fix it, however I have over 150 channels (multicast Ip's). That would not have been a good solution.Changing to Sparse-dense mode resolved all my issues and it is running much better now.ThanksDon
Ok this sort of works...The light finally came on. The set ip next-hop fix my problems going through the firewall and I fix the loca networks by denying them in the accesslist mentioned in the match statement..So here is a small part of the ACL for p...
Ok I will see if I can run out to work and try this today..After thinking about this, If I need to get to local ip addresses (192.168.1.0 and 192.168.128.0), I might have to change my route map to include those ranges in an ACL, then assign the 172.2...
Here is the relvant parts. I took out the physical interface commands. As you can see I simplfied my first question as far as my networks go. They are actually different than my first post. There are a lot of "x"s that I started to change the names, ...
