Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We can see the main site A with the multi-homing BGP configuration (mode default route with ISP) as attached.Currently, I don't have IGP on the site A (static route only)I would like to add the site B in order to have a DR.I have the private link ...
Hello,I cannot explain this behavior of my router.The r02 configuration seems to be basic but I cannot connect in telnet or SSH mode (I can just in console mode ).In addition, I have the same configuration on my router r01 and it works. It's very str...
Hello,We have one AS and our IP addresses in PI (provider independente)We have two routers connected to two ISPs in multi-homed mode and it works properly.The routers R1 et R2 are located in the same datacenter (site A)ISP_1 ISP_2 | ...
Hello,I used to "ip routing" command in order to enable inter-vlan routing, for example with 3750 cisco.I have a 6503 cisco with SUP720 MSFC3. I was able to create some vlans but I can not configure inter-vlan routing.sw#conf tEnter configuration com...
Hello,I have two ISP with theirs own AS numbers.I have my own AS and my IP addresses in PI (provider independente)I am not in full table mode but I receive the default route of each of my ISP.So I can see that : On the primary router R1 :B* 0.0.0....
Hi,I have the same project now . So I'm currently working to upgrade existing network from 1Gig to 10 GIG.We have two sites.On the one hand we have one C6503-E with Sup720 (Site B)And the other hand two 7206VXR routers with NPEG1 (Site A).Both site...
Hi,Yes the site B could be connected with ISP C using BGP session. I'm used to 90 Mbits/s of Internet bandwith (both ISP A and B)I don't have limit about bandwith.As follow the illustration, the bandwidth is :ISP A : 50 Mbits/sISP B : 40 Mbits/sISP ...
Yes, you're right. It's single site with a requirement to access public Servers (does that belongs to me).For now, all my clients (http client) is connected from Internet (SDSL) and access to the PROD server ( web server).PROD server has a BGP IP Pub...
