Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I want to know the amount of bandwidth required for each of the following traffic:1) SCCP signalling during call setup and termination.2) H.323 signalling during gateway call setup for outgoing PSTN calls.3) Periodic keepalives between IP Phone...
Hi, I am facing a problem in input queue drops in my router. I am getting input drops in my Fast Ethernet interface. If I am replacing this with a Gigabit interface, I am not getting any drops. I can see that that max input queue length of both in...
Hi, In my 7940 IP Phones , I need the max line to be 4, but the phone should give busy trigger when one call is active.I tried by changing the Max line to 4 and the busy trigger to be 1. After doing this, I am getting a busy tone when I have an acti...
Hi Anver, Thanks a lot for your reply. So you mean to say like, the busy trigger option enables influences incoming calls and the MAX line option influences outgoing calls. My requirement is like this.Suppoese the busy trigger option is 2 by default....
Hi, In some instances I have seen "service mgcpapp" under the dial-peer. What is the difference between "application mgcpapp" and "service mgcpapp" under the dial-peer voice 10 pots? Are both serving the same purpose?Thanks,Pete
