Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have 2 NCS-5501-SE router and I would like to configure MPLS to have L2VPN working, for a migration, tomorrow...Currently, I have : - OSPF configured in both sides, and it send /32 IP of loopback- MPLS LDP neighbor seem UP- L2VPN circuit is ...
Hi all,I would like to redirect next hop for 1 address only, before when I have NX-OS, I have used policy based routing and it working very good, but unable to reproduce the same on IOS XR. Before on NXOS We enable Policy Based Routingfeature pbrWe c...
Hello all,I have read on some forums we need to activate some functions to have packet-length matching on ACL on NCS5500. SpoilerRP/0/RP0/CPU0:core01.par2(config-ipv4-acl)#301 deny tcp any 89.116.164.0/24 packet-length eq 0 RP/0/RP0/CPU0:core01.par2...
Hi all,My answer is probably basic, but I need to forward a VLAN received from my upstream to my customer, on another interface.How to do it ? Encapsulation ? Please help me with commands or link. I have eat google to see the answer but not found :((...
Dear all,
I'have two Cisco nexus 9000 and some configuration(J'ai deux Cisco nexus 9000 et quelques configurations)
interface Vlan50
no shutdown
ip access-group customers in
ip access-group 50-anti-ddos-in out
no ip redirects
ip address 1...
Hi, Thank you for answer.I not found how associate policy based routing to a sub-interface like : On NXOS
interface Vlan100
ip policy route-map TO_GPE On IOS XR : interface Bundle-Ether2.80
description "RESTRICTED"
ipv4 address X.X.X.X/X
flow data...
Maybe solved ... RP/0/RP0/CPU0:core01.par2(config-ipv4-acl)#hw-module profile tcam format access-list ipv4 src-addr dst-addr src-port dst-port proto packet-length frag-bit port-rangeSat Aug 19 00:06:47.487 CESTIn order to activate/deactivate this ipv...