Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have multiple fabric sites and I want a shared underlay multicast tree across them. Currently they have been configured as standalone multicast topologies because each site points to its own Borders as the PIM RP in the underlay. There is no wo...
HiI know I can anchor a L3 VN using MSRB in SD Access but if I have a simple L2VN that I hand off via a L2 Border in one site can I stretch that across to another fabric site and use it there? In principle I would think it is achievable. My edges i...
HiWe have an SDA deployment with 2 fabric sites linked by an SD Transit. Presently the only way out of both fabrics is via site 1 Border nodes. We have our site 2 underlay/Loopbacks in a particular range and the addressing is dished out via LAN Aut...
HiWhen we use Catalyst Center to deploy 802.1x/mab on either open, closed or low impact modes the 802.1x to mab fallback timer is 21 seconds by default. This is deployed as a 7 second tx-period and a max-reauth-req count of 3 as belowdot1x timeout t...
HiI have a requirement to profile devices based on IP range. This is easy if my subnets are on octet boundries. So I can match the 10.10.10.0/24 subnet with startswith 10.10.10 and that works fine.However if my subnet is, for example, 10.10.0.0/20 ...
It seems to Anchor a VN it must be a fresh one not already used in a site with Anycast gateways/L2VNs. That's a bit of a pain because you may, at a later date, want to Anchor a VN already in use at a site.I have to say that the Cisco documentation o...
Without needing to know the lab environment I think the easier question here is what scenarios block you from designating a VN as an achor VN? When I know those scenarios I can see if any of them apply to my deployment.I would have thought this is a...
Even stranger. I have a lab DNAC and it has several VN's. If I select one VN it allows me to select the Anchor option but if I select another VN the option is greyed out. Kev
How do I choose the option to Anchor a VN? If I go to my VN's either in the Global area or in the fabric site where I want to Anchor my VN the option is greyed out. Kev.
