Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all, I am having trouble configuring a 1410 bridge to accept clients. I am running SW 12.3(7)JA3. I set the bridge to Root mode and assign basic settings but cannot connect with a client. I can see the SSID broadcasting. Any ideas?
I am trying to configure an access point for indoor use in US. I would like to have the A radio set to 50 mW and the G radio set to 30 mW to get similar coverage pattern. However, the A radio keeps going back to 11 dB or 12 mW. I am using a Cisco ...
Unfortunately, I have been informed by Cisco that the 1410 will NOT accept any clients. It only uses the UNII 3 band and is not capable of taking clients. Explains why I could see the broadcasted SSID, but not connect. Thanks for the reply.
