Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a VPN Concentrator 3020 and remote clients using the VPN Client. Is it possible for the clients connected to the concentrator to exchange traffic between them? The challenge that I see is that the traffic from a client arrives to the concentra...
I have one cluster of Juniper firewalls in an OSPF routing domain with Cisco routers. A few weeks ago we put an inline Sourcefire IPS between the firewalls and the routers, and lately we see OSPF neighbor marked down on the firewalls, because of hell...
I have a NetOptics ByPass switch with a 10/100/1000BASE-T interface connected to a GigabitEthernet switch port on a 6509 IOS switch. The interface on the NetOptics is set to 1000 and auto. On the switch, the port is set with the following commands:s...
Hi,I would like to implement HA for our Cisco VPN Concentrator 3020 and I would like to know if the HA pair can be CVPN3020E-NRBUN-K9.My existing system is a CVPN3020E-RDBUN-K9.Thanks.
I'm trying to set up OSPF between a router and a VPN 3000 concentrator, but I can not get them to form an adjacency. When I do a show ip ospf nei on the router, the state of the concentrator is INIT. I've followed the docs to set up the Concentrator,...
Hi,That's not what I see in my implementation. I can ping each client from the 3000 concentrator, but one client can not ping the other. Is there any configuration that needs to be added to either the concentrator or/and the VPN clients?Thanks.
Thank you for your response. It sounds good if I use only group level RADIUS attributes, but what if I need to set up call back numbers and IP addresses by user? Is ACS capable of retriving these attributes from LDAP?
