Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a router (config is basically the same as 20 other routers we have installed)Outbound nat works ok and the users can get out without an issue. However when we try to telnet into the router from the outside (837 ADSL PPPoA) we cannot get a c...
Hi,I have a pix configured with a site to site vpn. The pix has a 10 user license and there are only 5 users on site.The pix is running out of licenses, I do a show local-host and get:Interface inside: 10 active, 10 maximum active, 2781 deniedIt look...
Ok, I think the answer is no but i'm going to ask anyway. Is it possible to telnet from a pix to an internal device?I have ssh access to a firewall and want to telnet onto an internal router....I you can't why not is it a security feature of is it ju...
Hi, This is a little note to make eveyone aware of the issue I have come across with Avaya IP Phones and the Pix. I have an IP phone on the outside interface with my phone system on the inside. Everything works great for a few hours (or a clear xlate...
I have the following config running on a 515 URInternet | | Pix -- Wan DMZ -- Router --- ATM Cloud---Router -- Remote Net | |InternalThe problem I have is that my remote net can ping the internet but cannot b...
Strange configuration, you should re think this, PIX 1 should be turned around, but this is a really messy network design, Can you change things around ofr is the configuration fixed?
My understand of easy vpn is that it can only be used to configure a single connection. for subsequent connections you would have to manually configure the tunnels
is there a nat device on the network? A lot of nat devices will support the first vpn user (the ports used for VPN are mapped for the first host). Subsequent users cannot get a connection because the ports are already in use.First check out what the ...
The ip of D1 is appllied by the ISP on connection to the DSL network"In your configuration make sure that the nat is applied at the end of process" what do you mean by this, the nat is applied the configuration I cannot control where in the configura...
